COTS PRODUCTS > COTS DIGITAL / ANALOG PRODUCTS > Single Board Computers > AT-VME-SBC-PPC750CXe
 
VME 6U Single Slot SBC
Compliant with VME64x Architecture
Processor - PowerPC 750CXe from IBM
Up to 256 KB L2 caches
Clock Frequency - 600 Mhzs
Available in two variants - Air-Cooled, Conduction Cooled
Front and Rear I/O connectivity options
SDRAM Memory - Up to 512 MBs
User Flash Memory - Up to 32 MB
Boot Flash Memory - Up to 8 MB
Non-Volatile RAM - 32 KBs
1GB Nand Flash- Optionals
128MB Flash File- Optionals
Two 10/100 Ethernet interfaces
Ultra SCSI interface
Two USB 2.0 ports
Two dual redundant MIL-STD-1553B channels- optional
Two Multi-Protocol High Speed Synchronous serial ports (HDLC, SDLC, Bisync)
Four serial UART ports
16 Digital I/O channels
One PMC slot
Four on-board 32-bit counter/timers
Real Time Clock & Watchdog Timer
Linux, VxWorks and LynxOS available
 

AT family of 6U VME 64x bus compatible Single Board Computers (SBC) are based on PowerPC processors from IBM. The SBC is fully compliant to ANSI/VITA 1.1-1997 VME64x standard. The AT-VME-SBC is a rugged single slot SBC powered by IBMs PowerPC 750CXe low power, high performance processor series, featuring state of the-art Reduced Instruction Set Computer (RISC) architecture. It offers superior computing power providing up to 256 KB of L2 cache1, up to 600 MHz of clock speed2, up to 512 MB of SDRAM with ECC Protection, 8 MB of Boot Flash, 32 MB of User Flash and 32 KB of NVRAM. There is also an option for providing 128 MB of High-Density Flash File for mass storage purposes. The AT-VME-SBC has its internal architecture based on two separate PCI buses, one operating at 66MHz and the other at 33MHz, allowing the separation of the slower PCI devices from the faster ones. This enables each of the PCI devices to operate at their maximum speeds. In addition to the high performance processor architecture, the SBC provides multi-protocol interfaces in the form of two dual redundant MIL-STD-1553B channels (available optionally), two high-speed synchronous serial ports, four standard UART serial ports and 16 digital I/O channels. The SBC also features a watchdog timer, Real Time Clock and comes equipped with one PMC module site.

CPU
Processor: One PowerPC 750CXe
Clock Frequency: Up to 600 Mhz
Cache: 256 KB of L2 cache1
Memory
PowerPC System controller is GT-64260 controller from Marvell
Global Memory: Up to 512 MB SDRAM
ECC: Standard
Boot Flash: 8 MB
User Flash: 32 MB
NVRAM: 32KB
Flash File: Up to 128 MB (Optional)
Nand Flash: Up to 1GB (Optional)
VME Interface
Tundra UNIVERSE-II PCI-VME bridge controller
VME64x backplane interface
A32/A24/A16 master/slave
5 row connectors
PCI Interface
PCI 32/64 bit
33 or 66 MHz selectable PCI frequency
Fully compliant to PCI Specs- Rev 2.2
PMC Interface
Compliant to IEEE 1386/1386.1- 2001
One PMC slot
I/O (P4) Signals are routed to VME P2 connector
I/O Interfaces
2 on-board dual redundant MIL-STD-1553B channels-Optional
Ultra SCSI interface
Two USB ports
One PMC slot
Two 10/100 Ethernet ports
Two Synchronous serial buses
One each of RS-232 and RS-422 serial ports- Front Panel
Two serial ports programmable as RS-232/422- Rear I/O
16 TTL/CMOS voltage level digital I/O channels
JTAG
On-board JTAG interface to the processor for debugging and development purposes
Mechanical
6U VME 64x single slot interface
Dimensions- 233.35mm x 160mm
Weight
Air-Cooled version- 500 gm
Conduction cooled version- 625 gm
Power
Derived form +5.0V of VME64x backplane
3.3V, 2.5V, 1.8V are generated from on-board power circuitry
3.3V alternately derived from VME64x backplane
Current consumption < 6.5A
Test And Diagnostic Software
Boot software for initialization
Monitor/Debugger tool
BIT/POST software
Operating Systems
RT-Linux (Kernel Ver 2.4) driver Support
Compliant to POSIX standards
Environmental
  Air-Cooled Conduction-Cooled
Operating temperature -20°C to +65°C -40°C to +85°C
Storage Temperature -40°C to +85°C -45°C to +100°C
The temperature range for conduction-cooled boards is the operating card edge temperature
Meets MIL-STD-810F standards for temperature, shock, vibration etc
Meets MIL-STD-461C Part-II standards for EMI/EMC
Ruggedization
Series A: Air-Cooled Version - As per IEEE 1101.10
Series R: Conduction-Cooled Version - As per IEEE 1101.2
Warranty
1 year limited warranty
 
CORPORATE   ABOUT   FOLLOW US ON
AdTEC Electronics Inc.
4677 Old Ironsides Drive
Ste 230
Santa Clara, CA 95054
USA
 
AdTEC Electronics specializes in providing end-to-end custom product design & development encompassing System, Mechanical, Board Electronics, Chip design, Firmware and Application Software Engineering. Our design capabilities include design for testability and rugged design to meet both commercial and stringent regulations.
 
HOME ABOUT US COTS PRODUCTS SERVICES & SOLUTIONS SUPPORT & RESOURCES NEWS & EVENTS BLOG CONTACT US
AdTEC Electronics Inc.